Sam4s SPS-320 - Program Mode Programming; Descriptor Programming Methods; Program Overlay Method

Sam4s SPS-300 OP Manual v1.35 Service Mode Programming • 133
RS232C Settings Screen Program Notes
Option Description
BAUD RATE
Select 9600, 1200, 2400, 4800, 9600, 19200, 38,400,
57,600, or 115,200 from the pop-up window; 9600 is
default.
PARITY
Select NONE, EVEN, or ODD from the pop-up
window; NONE is default.
DATA BITS
Select 8 or 7 from the pop-up window; 8 is default.
STOP BITS
Select 1 or 2 from the pop-up window; 1 is default.
DEVICE FUNCTION
Enter the code number for the device you wish to
attach to this port from the code numbers displayed.
The device function codes are:
1: PC Communications
2: Scale
3: Remote Journal Printer
4: Remote Printer
5: Liquor
6: Scanner
7: Coin Dispenser
8: Reserved
9: Remote Pole Display
10: EFT (i.e. DataTran)
11: PDC (DataTran Peripheral Device Controller)
PRINT LINE ON GUEST
CHECK (0-50)
Enter the number of lines that represent the maximum
that can be printed on a single guest check.
SCALE TYPE
Select the digit that represents the scale type connected
to this port.
PRINTER TYPE
Select the digit that represents the printer type
connected to this port.
POLE DISPLAY TYPE
Select the digit that represents the pole display type
connected to this port.
RS232C RETRY TIMES
Set the number of retries for RS232C communication
(about 0.5 seconds each.)