134 • Service Mode Programming Sam4s SPS-300 OP Manual v1.35
SD Card Operation
Utilities in this program include:
• Program Backup & Loading
• Report Backup
• Pre-Image Logo Loading & Backup
• Post-Image Logo Loading & Backup
Flash ROM update can also be done by SD card or through a serial connection to a PC.
Note: The SD slot is located inside the printer compartment. On the SPS-320, the SD slot is
located to the right of the printer mechanism; on the SPS-340 and 345, the SD slot is located to
the rear of the receipt printer.) Remove the security screw to access the slot. See page 20 for
detail.
At the S control lock position menu, press 9 for SD Card Operation. The SD CARD
OPERATION screen displays:
SD CARD OPERATION
1. PROGRAM BACKUP
2. PROGRAM LOAD 3. REPORT BACKUP
4. PRE-IMAGE LOGO LOAD
5. PRE-IMAGE LOGO BACKUP
6. POST-IMAGE LOGO LOAD
7. POST-IMAGE LOGO BACKUP
8. EACH PROGRAM LOAD
Insert the SD card in the register’s SD slot.
Enter the digit (1-8) corresponding to the function you wish to access. A complete
explanation of each function follows.
Note: Option “8”, EACH PROGRAM LOAD was added at firmware version 1.038.
This option allows you to select an individual program segment to load. Program
components you can load individually include:
PLU Group
Tax System Options
Print Options Function Key
Clerk Logo Desc.
Report Logo Stock
Misc. Macro
PLU Lookup Mix & Match
To Next Page
Loading...
