162 • Program Mode Programming Sam4s SPS-300 OP Manual v1.35
TAX #1 PROGRAMMING
TAX RATE 0.000
When the arrow is pointed at the TAX RATE field, enter the percentage rate for the
sales tax. For example: if the tax is 6 percent, enter 6.000 or 6.0. If the tax is 7.5
percent, enter 7.500 or 7.5 using the decimal key. If the tax is 10 percent, enter
10.000 or 10.0. Press CASH to set the rate.
The TAX PROGRAMMING screen will return prompting you to enter the next tax,
if necessary. Continue to program additional taxes or press CLEAR to return to the
PROGRAM MODE screen.
Programming a Tax Table
In some cases, a tax that is entered as a percentage does not exactly follow the tax charts that
apply in your area (even if the tax chart is based on a percentage). In these cases, we
recommend that you enter your tax using tax table programming. This method will match tax
collection exactly to the break points of your tax table.
Before programming, obtain a copy of the tax table you wish to program. You will need the
printed tax table if you wish to determine the break point entries yourself. The "Tax Table
Programming Example - Illinois 6% Tax Table" on page 165 is used as an example in the steps
that follow.
Note: You can enter up to 75 break points.
Turn the control lock to the PGM position.
From the PROGRAM MODE menu, press 2 to view the TAX PROGRAMMING
screen:
TAX PROGRAMMING
TAX NUMBER (1-4) 1
DESC : TAX1
TAX TYPE (0-2) 1
0 : ADD-ON
1 : TAX TABLE
2 : VAT
When the arrow is pointed at the TAX NUMBER field, enter the number of the tax
you wish to program. (There are four taxes available, enter 1, 2, 3, or 4.)
To Next Page
Loading...
