Chapter 3. Installing the Product 3 - 41
You can specify this time period in seconds.
IP Address
Enter the IP address of the server being used. Consult your network administrator
before specifying this option.
Port No.
Enter the port number for the server being used. Consult your network administrator
before specifying this option.
Retry Interval
Specify how many seconds the system will wait before it retries a failed transmission.
You can specify this time period in seconds.
Maximum Retries
Specify how many times a failed transmission will be retried.
Storage Server Information
Select STORAGE under Services. Configure the Image Storage Service using DICOM.
Storage Options
- Send Cine Loops: Select this checkbox to transfer Cine Loops.
- Include Pixel Spacing: In addition to the area information used in ultrasonography, the
area information used in CT or radiography is also included. Measurements can be
taken from a PACS system that does not support ultrasonic area information.
- Include 3D Volume: Select whether to send 3D volume data together with the 3D
images.
VOI LUT Setup
Configure VOI LUT (Value Of Interest, Look Up Table). Adjust the brightness and
NOTE
However, only 2D and 2D Color Mode images are supported. In Dual and
Quad Mode, the depths of the included images must be identical.
NOTE
Only select this option if you use a storage service that supports the 3D
volume data format used by Samsung Medison.
To Next Page