Sanyo PLC HF10000L User Manual

46
If the projector cannot reproduce proper video image,
select a specific broadcast signal format from among PAL,
SECAM, NTSC, NTSC 4.43, PAL-M, and PAL-N.
The projector automatically detects an incoming video signal,
and adjusts itself to optimize its performance.
When the Video System is 1035i, 1080i or 1080p, select the
system manually.
If the projector cannot reproduce proper video image, select
a specific component video signal format from among 480i,
575i, 480p, 575p, 720p, 1035i, 1080i, and 1080p.
Video Jack or S-video Jack
The projector automatically detects an incoming video
system, and adjusts itself to optimize its performance.
When Video System is PAL-M or PAL-N, select the
system manually.
Video Input
1
AV System menu (Video or S-video)
AV System menu (Y, Pb/Cb, Pr/Cr)
2
Press the MENU button to display the On-Screen Menu.
Use the Point ed buttons to select Input and then
press the Point 8 or the SELECT button.
Use the Point ed buttons to select System and then
press the Point 8 or the SELECT button.
3
Use the Point ed buttons to select the desired system
and then press the SELECT button.
✔Note:
The AV System Menu cannot be selected when selecting RGB
(Scart).
Video System Selection
Y, Pb/Cb, Pr/Cr Jacks
Auto
PAL/SECAM/NTSC/NTSC4.43/PAL-M/PAL-N
Auto
Y, Pb/Cb, Pr/Cr SIGNAL FORMAT

Sanyo PLC HF10000L Specifications

General

Matrix size	1.65 \
Matrix type	3-panel (p-Si TFT active)
Projection distance	- m
Vertical scan range	48 - 100 Hz
Horizontal scan range	15 - 120 kHz
Projection technology	LCD
Contrast ratio (typical)	3000:1
Screen size compatibility	- \
Projector native resolution	-
Keystone correction, horizontal	30 °
Interface	USB
Power LED	Yes
RS-232 ports	2
Dimensions (WxDxH)	530 x 757 x 268 mm
Focus	Auto
Focal length range	- mm
Noise level	43 dB
Noise level (economic mode)	39 dB
Dot clock scanning frequency	230 MHz
Lamp power	380 W
Lamps quantity	2 lamp(s)
Light source type	Lamp
Service life of light source	2000 h
Service life of light source (economic mode)	3000 h
Composite video in	0
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
S-Video inputs quantity	1
Wi-Fi	No
Analog signal format system	NTSC, NTSC 4.43, PAL, PAL M, PAL N, SECAM
Supported graphics resolutions	1024 x 768 (XGA), 1280 x 1024 (SXGA), 1600 x 1200 (UXGA), 1680 x 1050 (WSXGA+), 1920 x 1200 (WUXGA), 640 x 480 (VGA), 800 x 600 (SVGA)
Product color	Gray
Power consumption (standby)	18 W
Power consumption (typical)	955 W
Cables included	AC, RS-232

Weight and Dimensions

Weight	27600 g