Sanyo PLC HF10000L User Manual

49
✔Note
• When White balance Red, Green or Blue is adjusted, the
Color temp. level will change to Adj..
• Tint cannot be selected when the video system is PAL,
SECAM, PAL-M or PAL-N (p.46).
Press the Point 7 button to lighten red/green/blue tone
of the black level of an image; press the Point 8 button to
deepen red/green/blue tone of the black level of an image
(from 0 to 63).
Use the Point 7 8 buttons to select the desired Auto picture
control option (Off, L1 or L2).
Off
. . . . Auto picture control OFF position.
L1
. . . . . Auto picture control LEVEL 1 position.
L2
. . . . . Auto picture control LEVEL 2 position.
Use the Point 7 8 buttons to select the advanced color mode.
Off
. . . . Advanced color mode is “Off”.
Auto
. . . Advanced color according to the type of image .
*This function controls the operation of the Color Control
Device, which independently and automatically regulates the
amount of yellow light passing through the LCD panel, to
accurately reproduce both image color and image brightness.
Normally leave Auto (default setting).
✔Note:
• White balance may change depending on the image.
Video Input
Auto picture control
Advanced color*
Sharpness
Gamma
Offset (Red/Green/Blue)
Use the Point 7 8 buttons to adjust the gamma value to
obtain a better balance of contrast (from 0 to 15).
Press the Point 7 button to decrease the sharpness of the
image; press the Point 8 button to increase the sharpness
of the image (from 0 to 31).

Sanyo PLC HF10000L Specifications

General

Matrix size	1.65 \
Matrix type	3-panel (p-Si TFT active)
Projection distance	- m
Vertical scan range	48 - 100 Hz
Horizontal scan range	15 - 120 kHz
Projection technology	LCD
Contrast ratio (typical)	3000:1
Screen size compatibility	- \
Projector native resolution	-
Keystone correction, horizontal	30 °
Interface	USB
Power LED	Yes
RS-232 ports	2
Dimensions (WxDxH)	530 x 757 x 268 mm
Focus	Auto
Focal length range	- mm
Noise level	43 dB
Noise level (economic mode)	39 dB
Dot clock scanning frequency	230 MHz
Lamp power	380 W
Lamps quantity	2 lamp(s)
Light source type	Lamp
Service life of light source	2000 h
Service life of light source (economic mode)	3000 h
Composite video in	0
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
S-Video inputs quantity	1
Wi-Fi	No
Analog signal format system	NTSC, NTSC 4.43, PAL, PAL M, PAL N, SECAM
Supported graphics resolutions	1024 x 768 (XGA), 1280 x 1024 (SXGA), 1600 x 1200 (UXGA), 1680 x 1050 (WSXGA+), 1920 x 1200 (WUXGA), 640 x 480 (VGA), 800 x 600 (SVGA)
Product color	Gray
Power consumption (standby)	18 W
Power consumption (typical)	955 W
Cables included	AC, RS-232

Weight and Dimensions

Weight	27600 g