EasyManuals Logo

Sanyo PLC-XM100L User Manual

Sanyo PLC-XM100L
149 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #116 background imageLoading...
Page #116 background image
27
ENGLISH
L When PJ needs service:
TITLE: Message from projector
Projector Model Name:
model name
TCP/IP: 192.168.1.201 Projector Name: Proj05
It sends you following message.
*Maintenance requirement from Projector is detected.
CheckupLEDstatusofprojectorandconsultwiththedealer.
AD, 3.3V OK
KS, 3.3V OK
--- --- ---
MAIN, 3.3V NG
--- --- ---
Examples: Type and contents of alert mail
When the projector has an abnormality, the following alert messages are sent to the regis-
tered E-mail address according to your selected condition. Administrator or user can take
an efficient action quickly by receiving this message. This is very useful to maintain and
service the projector.
The following are examples of received messages.
L When internal PJ temperature is too high:
TITLE: Message from projector
Projector Model Name:
model name
TCP/IP: 192.168.1.201 Projector Name: Proj05
It sends you following message.
*The Projector lamp is turned off, because internal
projector temperature is too high.
Wait for the completion of the cooling process and make sure the projector has been
turned into Standby. Then turn the
projector on again.
If the Indicator continues flashing, check the air filter for dust accumulation.
The projector lamp was turned off, because the projector power circuit failed.
Unplug the AC power cord and plug it, and then turn on the projector once again to verify
operation. If the problem still persists, unplug the AC power cord and ask servicing to a
qualified service personnel with the error information.
Error information
E-mail setting

Table of Contents

Other manuals for Sanyo PLC-XM100L

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sanyo PLC-XM100L and is the answer not in the manual?

Sanyo PLC-XM100L Specifications

General IconGeneral
Vertical scan range48 - 100 Hz
Horizontal scan range15 - 100 kHz
Projection technologyLCD
Contrast ratio (typical)1000:1
Projector native resolutionXGA (1024x768)
Lamp typeNSH
Lamp power330 W
Light source typeLamp
Service life of light source2000 h
Service life of light source (economic mode)3000 h
Analog signal format systemNTSC, PAL, SECAM
S-Video inputs quantity1
Dimensions (WxDxH)489.5 x 371.1 x 164 mm
Noise level38 dB
Power consumption (standby)0.6 W
Power consumption (typical)400 W
Power consumption (economy mode)338 W
Weight and Dimensions IconWeight and Dimensions
Weight8900 g

Related product manuals