Sanyo PLC-XM100L User Manual

32
3Note:
You can choose the pattern of Pointer (Arrow/Finger/Dot)inthe
Setting Menu (p.58)
You can move the Pointer of the projector with the remote control to emphasize a part of the projected image.
Press the POINTER button to activate the Pointer function.
1
2
3
MOUSE POINTER button
POINTER button
To cancel the Pointer function, press the POINTER button
again or press any other button.
Use the MOUSE POINTER button to move the Pointer.
The remote control can be used as a wireless mouse for your computer.
Move the pointer on the
screen with this button.
MOUSE POINTER
button
R-CLICK button
L-CLICK button
Acts as right (click)
mouse button while the
projector and a computer
are connected with a USB
cable.
Acts as left (click) mouse
button while the projector
and a computer are
connected with a USB
cable.
Before operating the wireless mouse, connect your computer
and the projector with the supplied USB cable (p.19).
When the Pointer function is used, the wireless mouse is not
available.
When a USB cable is connected to the computer and the
projector, turn on the projector first, then the computer. If you
turn on the computer first, the wireless mouse function may
not operate properly.
1
2
Basic Operation
Pointer Function
Wireless Mouse Operation
z
Dot
Arrow
Finger

Sanyo PLC-XM100L Specifications

General

Vertical scan range	48 - 100 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	LCD
Contrast ratio (typical)	1000:1
Projector native resolution	XGA (1024x768)
Lamp type	NSH
Lamp power	330 W
Light source type	Lamp
Service life of light source	2000 h
Service life of light source (economic mode)	3000 h
Analog signal format system	NTSC, PAL, SECAM
S-Video inputs quantity	1
Dimensions (WxDxH)	489.5 x 371.1 x 164 mm
Noise level	38 dB
Power consumption (standby)	0.6 W
Power consumption (typical)	400 W
Power consumption (economy mode)	338 W

Weight and Dimensions

Weight	8900 g