Flow of installation
Flow of installation
To use the projector via the networks, follow the setup procedures below.
STEP 1
Connect the LAN and set the configuration.
STEP 2
Network Configuration has completed.
Decide depending on the LAN environment.
“2. Setup Procedures” (pp.11–16).
Detailed LAN configurations need to be done with a browser later.
First, complete the Wired LAN connection between computers and projec-
tors, then start browser configurations.
“3. Basic setting and operation” (pp.17–30).
Follow each chapter to operate the projector.
NOperate and manage the projector “4. Controlling the projector”(pp.31-44)
“Power Control and status check”(p.32)
“Control” (p.34)
“PC adjustment” (p.38)
“Setting up the projector”(p.39)
“Projector information”(pp.42-43)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
