15
12 3
Open the battery
compartment lid.
Install new batteries into
the compartment.
Replace the
compartment lid.
Press the lid downward and
slide it.
Two AAA size batteries
For correct polarity (+ and
–), be sure battery terminals
are in contact with pins in the
compartment.
To ensure safe operation, please observe the following precautions :
Ɣ 8VHWZR$$$RU/5W\SHDONDOLQHEDWWHULHV
Ɣ $OZD\VUHSODFHEDWWHULHVLQVHWV
Ɣ 'RQRWXVHDQHZEDWWHU\ZLWKDXVHGEDWWHU\
Ɣ $YRLGFRQWDFWZLWKZDWHURUOLTXLG
Ɣ 'RQRWH[SRVHWKHUHPRWHFRQWUROWRPRLVWXUHRUKHDW
Ɣ 'RQRWGURSWKHUHPRWHFRQWURO
Ɣ ,IWKHEDWWHU\KDVOHDNHGRQWKHUHPRWHFRQWUROFDUHIXOO\ZLSHWKH
case clean and install new batteries.
Ɣ 5LVNRIDQH[SORVLRQLIEDWWHU\LVUHSODFHGE\DQLQFRUUHFWW\SH
Ɣ 'LVSRVHRIXVHGEDWWHULHVDFFRUGLQJWRWKHLQVWUXFWLRQV
Point the remote control toward the projector (to Infrared Remote
Receivers) when pressing the buttons. Maximum operating range
for the remote control is about 16.4’ (5 m) and 60 degrees in front,
back and top of the projector.
Infrared Remote Receivers are provided in front, back and top of of
the projector. You can conveniently use all of the receivers (pp. 10,
11, 57).
16.4’
(5 m)
The remote control can be used as a wired remote control. Wired
remote control helps you use the remote control outside of the
operating range (16.4’/ 5 m). Connect the remote control and the
projector with the remote control cable (sold separately). Connected
with the remote control cable, the remote control does not emit
wireless signal.
Part Names and Functions
16.4’
(5 m)
3Note:
When hanging the projector from the ceiling, select the Infrared
Remote Receiver which is located farther away from the fluorescent
light (p.57).
Remote Control Battery Installation
Wired Remote Control Transmitter
Remote Control Receivers and Operating Range
To Next Page
Loading...
Need help?
General
Weight and Dimensions
