Sanyo PLC-XM100L User Manual

34
Chapter 4 Controlling the Projector
Control
Click Control on the main menu. The setting method differs depending
on the contents of the page. Click on the page number to change pages
and select desired setting items.
 Please see the owner's manual of the projector to have the further information
of each control item.
 The control page displays valid control items depending on the selected input mode, signal
or functions of the projector you use, therefore, there may be different controls between the
described items and actual control items on the page display. For further information , refer to the
projector's owner's manual.

When the projector is in standby, all the controlling items are inactive.
Item Description
Input.........................Selects input mode of the projector.
Source.....................Selects signal source of the input.
RGB : RGB (PC analog)
RGB (Scart)
RGB (PC digital)
RGB (AV HDCP)
5BNC : Video
Y, Pb/Cb, Pr/Cr
RGB
VIDEO : Video
Y, Pb/Cb, Pr/Cr
S-video
Input
This function is to select the input mode and source mode of the projector. Click Set but-
ton after selecting the input and source mode.

Sanyo PLC-XM100L Specifications

General

Vertical scan range	48 - 100 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	LCD
Contrast ratio (typical)	1000:1
Projector native resolution	XGA (1024x768)
Lamp type	NSH
Lamp power	330 W
Light source type	Lamp
Service life of light source	2000 h
Service life of light source (economic mode)	3000 h
Analog signal format system	NTSC, PAL, SECAM
S-Video inputs quantity	1
Dimensions (WxDxH)	489.5 x 371.1 x 164 mm
Noise level	38 dB
Power consumption (standby)	0.6 W
Power consumption (typical)	400 W
Power consumption (economy mode)	338 W

Weight and Dimensions

Weight	8900 g