EasyManuals Logo

Sanyo PLC-XM100L User Manual

Sanyo PLC-XM100L
149 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #69 background imageLoading...
Page #69 background image
69
The WARNING indicators show the state of the function which protects the projector. Check the state of the WARNING
indicators and the POWER indicator to take proper maintenance.
The projector is shut down and the WARNING
TEMP. indicator is blinking red.
When the temperature inside the projector reaches a
certain level, the projector will be automatically shut down to
protect the inside of the projector. The POWER indicator is blinking
while the projector is being cooled down. When the projector has
cooled down enough (to its normal operating temperature), it can
be turned on again by pressing the ON/STAND-BY button.
3Note:
The WARNING TEMP. indicator continues to blink even after the
temperature inside the projector returns to normal. When the projector
is turned on again, the WARNING TEMP. indicator stops blinking.
Then check the matters below:
Did you provide appropriate space for the projector to be
ventilated? Check the installing condition to see if the air vents of
the projector are not blocked.
Has the projector been installed near an Air-Conditioning/
Heating Duct or Vent? Move the installation of the projector away
from the duct or vent.
Is the filter clean? Replace the filter with a new one.
The projector is shut down and the LAMP indicator is
lighting and other indicators are blinking.
When the projector detects an abnormal condition, it will
be automatically shut down to protect the inside of the
projector and the LAMP indicator lights on and other indicators
blink. In this case, unplug the AC power cord and plug it, and then
turn on the projector once again to verify operation. If the
projector cannot be turned on and these indicators are still lighting
and blinking, unplug the AC power cord and contact
the service station.
CAUTION
DO NOT LEAVE THE PROJECTOR WITH THE
AC POWER CORD CONNECTED UNDER AN
ABNORMAL CONDITION. IT MAY RESULT IN
FIRE OR ELECTRIC SHOCK.
Top Panel
LAMP indicator lights on and
other indicators blink.
Top Panel
WARNING TEMP.
blinking red
Maintenance and Care
Warning Indicators

Table of Contents

Other manuals for Sanyo PLC-XM100L

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sanyo PLC-XM100L and is the answer not in the manual?

Sanyo PLC-XM100L Specifications

General IconGeneral
Vertical scan range48 - 100 Hz
Horizontal scan range15 - 100 kHz
Projection technologyLCD
Contrast ratio (typical)1000:1
Projector native resolutionXGA (1024x768)
Lamp typeNSH
Lamp power330 W
Light source typeLamp
Service life of light source2000 h
Service life of light source (economic mode)3000 h
Analog signal format systemNTSC, PAL, SECAM
S-Video inputs quantity1
Dimensions (WxDxH)489.5 x 371.1 x 164 mm
Noise level38 dB
Power consumption (standby)0.6 W
Power consumption (typical)400 W
Power consumption (economy mode)338 W
Weight and Dimensions IconWeight and Dimensions
Weight8900 g

Related product manuals