SATO S84NX - Page 101

Back to top 4 Replacement
S84NX/S86NX Service Manual
99
4
Remove three screws (S7) and remove the USB unit (
3
).
5
Carefully pull out the USB cable from the printer and disconnect the connector (
4
) from the
USB unit (
3
).
6
Remove two screws (S2) and remove the USB PCB (
5
).
S7
3
4
S2
5
Notes on assembling
• Attach the USB unit so that the SENSOR SW BR cable (
3
) is
not pinched.
3

From here, assembling procedure
7
Assemble the parts in the reverse order of the disassembly procedure.