SATO S84NX - Printing Quality

S84NX/S86NX Service Manual
50
Back to top 3 Checking and Performing Printer Adjustments
3.3.4 Printing Quality
2 min
Perform the test print with the factory settings and check that there is no problem with printing quality.
1
Place the label on the printer.
2
Select [Settings]
>
[Tools]
>
[Test Print]
>
[Factory]
>
[ ] (right select button).
3
After printing multiple labels, select [ ] (right select button) to stop the printing.
Media feed
direction
1
Is there any quality degradation compared with the test print before starting work?
2
Is the print quality uniform?
If the print quality is not uniform and hard to correct, lower the print darkness, and then check the
test print results again.
3
Is printing shrunk
Pay attention to the ruled lines. If the ruled lines are missing, check the drive part as it may be the cause.