SATO S84NX - HEX-Dump

Back to top 2 Operation and Confi guration
S84NX/S86NX Service Manual
15
2.2.2 HEX-Dump
Enable or disable the Hex Dump mode.
If you enable [Hex Dump Mode], the product prints the received data and at the same time creates a
fi le of the received data inside “hexdump/”.
If you return the setting to disabled, you can check the fi le on the screen.

Buff er Dump
Save the receive buff er data to the product.
Available only if you disabled the [Hex Dump Mode] menu.
Tap [START] on the startup screen to save the data to the product.
Save the receive buff er data to “buff /” in the product.

Log Files
Save the receive buff er data to the product.
Copy
buff /
Copy the selected log fi le to the USB memory.
Note
The data obtained by the buff er dump operation is stored.
hexdump/
Copy the selected log fi le to the USB memory.
Note
The data obtained by the hex dump (enabled) operation is stored.
Remove
buff /
Delete the log fi les of the printer.
hexdump/
Print
buff /
Print the selected log fi les.
hexdump/