SATO S84NX - Replacing the Ribbon End Sensor

Back to top 4 Replacement
S84NX/S86NX Service Manual
93
4.5.3 Replacing the Ribbon End Sensor
Procedure Reference
1
Open the front housing cover of the product.
Refer to 4.2.2
2
Open the rear housing covers of the product.
Refer to 4.2.1
3
Remove the gearbox from the product.
Refer to 4.4.8
4
Remove the print head from the product.
Refer to 4.3.1
5
Remove the ribbon rewind spindle.
Refer to 4.4.5
Step 1
Step 5
Step 2
Step 3
Step 4
6
On the front of the product, remove two screws
(S3) and the belt cover (
1
).
S3
S3
1