SATO S84NX - Sensors; Replacing the Media Sensor

Back to top 4 Replacement
S84NX/S86NX Service Manual
87
4. 5 Sensors
4.5.1 Replacing the Media Sensor
There are three types of media sensors as follows:
• TOP MEDIA SENSOR PCB
• BOTTOM MEDIA SENSOR PCB
• MEDIA SENSOR ASSEMBLY OPEN SENSOR
1
1
Open the top cover (
1
) of the product.
NOTE
• Open the top cover fully to prevent accidental drop of the cover.
2
Remove three screws (S2) attaching the media sensor assembly (
3
) to the center frame.
To access the lower screw, you need to pull the
feed lock latch
(
4
) to unlock the media sensor
assembly.
S2
S2
3
4
3
Withdraw the media sensor assembly (
3
).
Be careful not to pull the
attached sensor cable
(
4
).
3
4