SATO S84NX - Replacing the Ribbon Sensor

Back to top 4 Replacement
S84NX/S86NX Service Manual
91
4.5.2 Replacing the Ribbon Sensor
1
Open the top cover (
1
) of the product.
NOTE
• Open the top cover fully to prevent accidental drop of the cover.
2
Open the rear housing covers of the product.
Refer to
4.2.1 Opening the Rear Housing Cover
1
3
Disconnect the ribbon feed sensor cable (
2
).
2
4
On the front of the product, remove two screws
(S3) and the belt cover (
3
).
S3
S3
3