SATO S84NX - Meandering; Checking and Adjusting the Print Position; Checking the Stop Position

S84NX/S86NX Service Manual
51
Back to top 3 Checking and Performing Printer Adjustments
3.3.5 Meandering
1 min
Perform the test print with the factory settings and check that the printing is not meandering in
horizontal direction.
1
Is the media meandering?
If you cannot eliminate the meandering, replace the roller.
2
After installing all the units, check for meandering again.
3.3.6 Checking and Adjusting the Print Position
1 min
Perform the test print with the factory settings and check that no print position deviation occurs. If it
occurs, perform adjustment to correct it.
Note
When you have adjusted the sensor levels, be sure to check the print position.
Check that the print position on the 1st and 3rd labels is stable.
If the problem persists, perform sensor adjustment again and recheck the roller, etc.
3.3.7 Checking the Stop Position
1 min
Perform the test print with the factory settings and check that no stop position deviation occurs. If it
occurs, perform adjustment to correct it.
Note
When you have adjusted the sensor levels, be sure to check the stop position.
1
Check that the stop position on the 1st and 3rd labels is stable.
2
No print skips occurs.
If the problem persists, perform sensor adjustment again and recheck the roller, etc.