SATO S84NX - Replacing the Media Feed Roller

Back to top 4 Replacement
S84NX/S86NX Service Manual
77
4.4.4 Replacing the Media Feed Roller
1
Open the top cover (
1
) of the product.
NOTE
• Open the top cover fully to prevent accidental drop of the cover.
1
2
Pull the feed lock latch (
2
) to unlock the feed roller and media sensor assembly (
3
).
The feed roller and media sensor assembly will flip open.
2
3
3
Loosen the screw (S3) until the bearing clamp (
4
) is released.
Do not remove the screw.
S3
4
Notes on assembling
• While aligning the bearing clamp with the
media feed roller, tighten the screw.