SATO S84NX - Printing Section Replacement

Back to top 4 Replacement
S84NX/S86NX Service Manual
70
4. 3 Printing Section
4.3.1 Replacing the Print Head
WARNING
• Do not touch the power switch, connect or disconnect the power cord while your hands are wet.
Doing so could cause an electric shock.
• Disconnect the power cord from the AC outlet before you replace the print head.
• Wear gloves before replacing the print head, to prevent damage to the print head.
1
Open the top cover (
1
) of the product.
NOTE
• Open the top cover fully to prevent accidental drop
of the cover.
1
2
Turn the head lock lever (2) clockwise to unlock
the print head.
NOTE
• The print head and its surroundings are hot after
printing. Be careful not to touch it, to avoid being
burned.
• Touching the edge of the print head with your bare
hand could cause injury.
3
Loosen the HEAD CABLE COVER thumb screw
(
3
) and remove the HEAD CABLE COVER.
3
2