SATO S84NX - Page 73

Back to top 4 Replacement
S84NX/S86NX Service Manual
71
4
Pull the tab (
4
) to remove the print head (
5
).
Support the print head with your hand when the
print head
is released.
4
5
5
Pull out the print head (
5
) and disconnect all
connectors (
6
).

From here, assembling procedure
Notes on assembling
• PHandle the print head with care. Do not contaminate
or scratch the sensitive print head surface.
6
Connect all the connectors (
6
) to the new print
head.
5
6
7
While pulling the cables (
7
) from the print head backwards, install the print head (
5
).
Notes on assembling
• Align the print head and press the print head upward until it is latched.
5
7
8
8
Reverse the procedure from step 3.
Reverse the procedure from step 3.