SATO S84NX - Page 96

Back to top 4 Replacement
S84NX/S86NX Service Manual
94
7
Then remove the screw (S2) and remove the cable cover (
2
).
8
Disconnect the ribbon end cable (
3
) from the connector.
9
On the rear of the product, remove three screws (S4).
10
Then carefully remove the frame of the print head assembly (
4
).
S2
S4 S4
4
2
S4
3
11
Remove the screw and replace the ribbon end
sensor (
5
).
5
Screw

From here, assembling procedure
12
Assemble the parts in the reverse order of the disassembly procedure.