S84NX/S86NX Service Manual
40
Back to top
3 Checking and Performing Printer Adjustments
1
Is there any abnormal noise?
2
Check the print position and stop position.
Print on multiple labels and check that the position of each block is stable.
3
Firmware version
Update the fi rmware version as required.
4
Check the head counter information.
5
The password for the [Service] menu
6
Check the sensor levels.
If the sensor level is outside of the following range, adjust the sensor level.
Voltage REFLECTIVE TRANSMISSIVE
LOW 0.5 V or less
HIGH High – Low
1.0 V
Refer to
3.3.3 Checking and Adjusting the I-mark Sensor and Gap Sensor
CAUTION
After completion of the above check, print various setting information so that you can check it later.
To Next Page
Loading...