7 Parameter menu
Operating instructions for actuators type AB with SMARTCON control unit
OM-ENGLISH-CSC-V2.08-2019.11.07
Figure 64
If at least one of the characteristic curve is activated, it is shown in the graphical display (see Figure 65 40)
Figure 65: 1. . . Characteristic curve enabled
Menu Item
Sub-Menu
item
poss. setting Notes / Comments
P17.1 Characteristic Torque Open Off
The torque characteristic curve is disabled for the
OPEN direction
On
The torque characteristic curve is enabled for the
OPEN direction
Local + Remote
only
The torque characteristic curve is enabled for the
OPEN direction only in LOCAL and REMOTE
mode (while disabled in the EMERGENCY mode)
P17.2 Characteristic
Torque
Closed
Off
The torque characteristic curve is disabled for the
CLOSED direction
On
The torque characteristic curve is enabled for the
CLOSED direction
Local + Remote
only
The torque characteristic curve is enabled for the
CLOSED direction only in LOCAL and REMOTE
mode (while disabled in the EMERGENCY mode)
40
To Next Page
Loading...
