Schwarze Industries Hypervac - Page 35

Section 3 - Pre-Operation
HV-18 revised 11/18 SCHWARZE HYPERVAC 35
Operator Notes:
______________________________
______________________________
______________________________
______________________________
______________________________
______________________________
______________________________
______________________________
______________________________
______________________________
______________________________
______________________________
______________________________
______________________________
______________________________
______________________________
______________________________
______________________________
______________________________
______________________________
______________________________
______________________________
Fan & Housing
□ ¼” clearance between the smallest diameter of the fan inlet scroll and the edge
of the back cover plate orifice.
□ Fan blades are clean and free from debris
□ Drive belt correctly adjusted and not slipping
Hopper
□ Hopper seals are in place and seal properly in lowered position
□ Hopper screens are clean and free of debris
□ Hopper suction inlet tube is clean and free of debris
□ Dust separator opens and closes freely with tilt function of the hopper
□ Inspection door seals are in place and seal properly
□ Rear hopper seals are in place and seal properly with door closed and latched
□ Dump door closes and latches securely
□ Hand hose door closes and latches securely
Water System
□ Water tank has sufficient water
□ All nozzles are free of debris and operational
General
□ Unit is clean and free of tools, loose hardware, debris, etc.
Chassis Truck Pre-Operation Inspection
□ Inspect the rims and wheel nuts
□ Check the tires for wear, damage, and pressure
□ Inspect and check the braking system
□ Inspect and check the steering system
□ Inspect the suspension system
□ Inspect the exhaust system
□ Check the fuel level
□ Check the chassis engine oil and radiator fluid levels
□ Inspect the engine air cleaners
□ Check the transmission fluid level
□ Check the battery
□ Inspect all engine drive belts for wear
□ Check the windshield washer fluid level
□ Check operation of all lights and beacons
□ Adjust the mirrors
□ Verify that all emergency equipment is present
Sweeper ID#:_____________________ Make: Schwarze Hypervac _____
Truck ID#:________________________ Make: ______________________
Date:____________________________ Shift: _______________________
Operator’s Signature: ___________________________________________