Schwarze Industries Hypervac - High Pressure Washdown (if Equipped); Magnet Bar (if Equipped); Self-Dumping Magnet (if Equipped); Driver Position (if Equipped)

Section 4 - Operations
62 SCHWARZE HYPERVAC HV-18 revised 11/18
The hopper deluge; allows a 2-1/2” dia. re hose
connected to a re hydrant to be connected to the hopper
and allow the inside of the hopper and hopper screen to be
cleaned with a massive amount of pressurized water.
The Schwarze Deluge blasts free dirt and stubborn grime
adhering to the inside and drastically shortens sweeper
cleanup.
High Pressure Washdown (if equipped)
The washdown hose allows the operator to clean the
sweeper while in the eld when external water sources are
unavailable. The washdown hose spray nozzle can be set
from a wide spray to a narrow high-pressure stream when
needed.
Important: Before starting, all sweeper functions must be
turned off, engine ignition key on and engine running in
standby.
Turning the High Pressure Washdown On
1. Press the toggle switch to the “on” position.
Turning the High Pressure Washdown Off
1. Press the toggle switch to the “off” position.
Magnet Bar (if equipped)
The main function of the magnet bar is to remove metal
objects that may cause damage to the truck tires.
Note: Use of this function requires the auxiliary engine to
be turned on.
Lowering The Magnet Bar
1. Press the toggle switch to the “down” position.
2. Continue to hold the switch until the magnet bar is fully
lowered.
Note: The magnet bar will automatically stop when it
reaches the proper distance from the ground.
Raising The Magnet Bar
1. Press the toggle switch to the “up” position.
2. Continue to hold the switch until the magnet bar has
fully retracted against the up-stops.
Note: Unless equipped with a self-dumping magnet,
objects that were picked up must be manually removed
from the magnet.
Self-Dumping Magnet (if equipped)
Releasing (Dump) Objects From The Self-Dumping
Magnet.
1. Press the toggle switch to the “down” position.
Driver Position (if equipped)
This horizontal switch is located on the chassis center
console. It allows the operator to enable driving functions
from either side of the cab.
Important: It is recommended to always operate the
sweeper from the left side of the chassis while transporting
the sweeper at trafc speeds.
1. Stop the truck in a safe area and set the parking brake.
2. Take the truck transmission out of gear and put in
neutral.
3. Toggle the chassis hopper switch so that the right
steering position is empowered.
4. Realign the sweeper’s mirrors for the right hand
steering position.