Section 4 - Operations
HV-18 revised 11/18 SCHWARZE HYPERVAC 63
Arrow Board Control Panel (if equipped)
Press the appropriate directional switch to indicate your sweeping
operation.
1. The left side switch controls either left or right sweeping
indicator lights.
2. The right-side switch controls dual indicator lights on/off.
Drop Down Screen (if equipped)
1.
Turn the red switch to the down position to lower the hopper’s
internal screen for ease of cleaning
2. Once all debris is removed, turn the switch to the up position
to retract the screen to its sweeping position.
4.9 End of Shift Cleanup and Maintenance
Your new sweeper has been quality engineered to provide years
of dependable service. End of shift cleanup is a major factor in
keeping your unit in like-new condition.
Note: Allow at least half an hour at the end of a day’s sweeping to
properly clean the unit.
Danger: Before starting end of shift cleanup, always verify that:
• The truck is out of gear.
• The parking brake is engaged.
• Hopper safety props are into position.
Cleaning is an important part of any maintenance program
because it extends the life of the sweeper by reducing rust and
abrasion. Additionally, this gives the opportunity to inspect for any
damaged or worn parts needing service or replacement.
Generally, a high volume of water cleans best; using a re hose
with a high-velocity nozzle is the quickest and simplest cleaning
method. Other slower cleaning methods include the optional high
volume wash down nozzle or regular “garden hose”.
Note: Local rules and regulations may restrict you from using a
re hydrant for cleaning purposes.
Important: Do not spray water directly onto the engine
components, computer components or bearings.
To Next Page
Loading...