Section 4 - Operations
60 SCHWARZE HYPERVAC HV-18 revised 11/18
4.8 Additional Optional Equipment
Your sweeper may be equipped with a variety of additional
optional equipment.
Hand Hose (if equipped)
The hand hose is mounted on a hydraulic boom hinged
to the right rear of the sweeper. The hose operates via
suction within the hopper.
1. Press the hand hose switch on the aux bank.
Note: be sure to deselect standby to achieve full engine
RPM during hose operation.
2. Remove support straps and cords that hold the hose
in place on truck.
A) Hand Hose Transport Straps (Remove top to operate
hose)
B) Hand Hose Control Handle (With lift and throttle control)
1. Hose Boom Up/Down Control Toggle Switch.
2. Engine Throttle Control Rocker Switch.
Operating The Hand Hose
1. Pull the lock levers down on the hose door latch
located in the back of the sweeper to reveal the
suction door opening.
2. Swing the hand hose end in place flat against the
opening and lock the hand hose latches.
3.
Swing the boom out and away from the rear of the
hopper.
To Next Page
Loading...