8 of 11 SEL-587Z Settings Sheets
Port Settings (SET P Command)
SEL-587Z Instruction Manual Date Code 20020903
Date________________
Port Settings (SET P Command)
NOTE: The RTSCTS setting does not appear if PROTO=LMD or MOD; PREFIX, ADDR, and SETTLE do not appear if PROTO=SEL or MOD;
the SLAVE setting does not appear if PROTO=SEL or LMD. See SEL Distributed Port Switch Protocol (LMD) on page 6.10 in Section 6:
Serial Port Communications for details on LMD protocol and see Appendix D: Modbus RTU Communications Protocol for details on
Modbus protocol.
Port 1 (SET P 1) Rear Panel
Port Protocol (SEL, LMD, MOD) PROTO =
LMD Prefix (@, #, $, %, &)
PREFIX =
LMD Address (1–99)
ADDR =
LMD Settling Time (0–30 seconds)
SETTLE =
Baud Rate (300, 1200, 2400, 4800, 9600, 19200, 38400)
SPEED =
Number Data Bits (7, 8)
BITS =
Parity (Odd [O], Even [E], or None [N])
PARITY =
Stop Bits (1, 2)
STOP =
Timeout (for inactivity) (0–30 minutes)
T_OUT =
Send Auto Messages to Port (Y, N)
AUTO =
Enable Hardware Handshaking (Y, N)
RTSCTS =
Fast Operate Enable (Y, N)
FASTOP =
Modbus Slave ID (1–247)
SLAVE =
Port F (SET P F) Front Panel
Port Protocol (SEL, LMD) PROTO =
LMD Prefix (@, #, $, %, &)
PREFIX =
LMD Address (1–99)
ADDR =
LMD Settling Time (0–30 seconds)
SETTLE =
Baud Rate (300, 1200, 2400, 4800, 9600, 19200, 38400)
SPEED =
Number Data Bits (7, 8)
BITS =
Parity (Odd [O], Even [E], or None [N])
PARITY =
Stop Bits (1, 2)
STOP =
Timeout (for inactivity) (0–30 minutes)
T_OUT =
Send Auto Messages to Port (Y, N)
AUTO =
Enable Hardware Handshaking (Y, N)
RTSCTS =
Fast Operate Enable (Y, N)
FASTOP =
To Next Page
