1.2
SEL-587Z Instruction Manual Date Code 20020903
Introduction and Specifications
Overview
Overview
Instruction
Manual
This instruction manual applies to the SEL-587Z. If you are unfamiliar with
the relay, read the following sections in the outlined order.
Section 1: Introduction and Specifications. Provides a brief overview of
the capabilities and general specifications of the relay.
Section 3: Relay Elements. Describes protection features and applications
of the SEL-587Z.
Section 4: Control Logic. Explains the relay logic and logic inputs,
SEL
OGIC
®
control equations, Relay Word bits, and relay outputs.
Section 5: Setting the Relay. Outlines making setting changes and
includes the Settings Sheets.
Section 6: Serial Port Communications. Describes configuring the relay
for serial communication and gives specific data on relay
communications protocols.
Section 7: ASCII Command Reference. Presents an alphabetic list of relay
ASCII commands used for control, viewing target information, and
obtaining metering information.
Section 8: Front-Panel Interface. Explains monitoring and controlling the
relay using the front panel.
Section 9: Event Reports and SER. Details event report generation,
summary event report information, event report details, and
interpreting event report data. This section also presents formats and
applications of the Sequential Events Recorder (SER).
Section 2: Installation. Describes configuring, installing, and wiring the
relay.
Section 10: Testing and Troubleshooting. Lists test procedures and a
troubleshooting guide. You can use this section as a tutorial to check
your understanding of relay operation.
Hardware
Figure 1.1 shows the front panel of the SEL-587Z.
Figure 1.1 SEL-587Z Front Panel.
To Next Page
