Schweitzer Engineering Laboratories SEL-587Z - List of Tables

Date Code 20020903 SEL-587Z Instruction Manual
List of Tables
Section 2: Installation
Table 2.1 Control Input Voltage Selection Jumper Positions................................................................. 2.8
Table 2.2 Required Position of Jumper JMP13 for Desired Output Contact OUT4 Operation........... 2.10
Section 3: Relay Elements
Table 3.1 Differential Elements ............................................................................................................. 3.3
Table 3.2 Instantaneous Overcurrent Elements.................................................................................... 3.10
Table 3.3 Inverse-Time Overcurrent Elements..................................................................................... 3.10
Table 3.4 Transformer Detail ............................................................................................................... 3.31
Table 3.5 Temperature Parameters (IEEE C57.91: 1995).................................................................... 3.32
Section 4: Control Logic
Table 4.1 Control Switch Position, Label Settings, and Local Control Switch State ............................ 4.5
Table 4.2 Local Bit Functions ................................................................................................................ 4.6
Table 4.3 Local Control Switch Types and Required Label Settings..................................................... 4.6
Table 4.4 Local Bit LB3 Used as Bus Zone ON/OFF Switch ............................................................... 4.7
Table 4.5 Processing Order of SEL
OGIC Control Equation Operators................................................. 4.11
Table 4.6 SEL
OGIC Control Equation Logic........................................................................................ 4.12
Table 4.7 Processing Order of Relay Elements and Logic (top to bottom) ......................................... 4.13
Table 4.8 SEL-587Z Front-Panel Target LED Definitions .................................................................. 4.24
Section 5: Setting the Relay
Table 5.1 SET Command Editing Keystrokes........................................................................................ 5.2
Section 6: Serial Port Communications
Table 6.1 EIA-232 and EIA-485 Pinouts ............................................................................................... 6.2
Table 6.2 Serial Communications Port Pin Function Definitions .......................................................... 6.3
Table 6.3 Serial Port Automatic Messages ............................................................................................ 6.6
Table 6.4 Binary Message List............................................................................................................. 6.11
Table 6.5 ASCII Configuration Message List...................................................................................... 6.11
Table 6.6 A5C0 Relay Definition Block .............................................................................................. 6.12
Table 6.7 A5C1 Fast Meter Configuration Block ................................................................................ 6.12
Table 6.8 A5D1 Fast Meter Data Block............................................................................................... 6.14
Table 6.9 A5C2/A5C3 Demand/PeakDemand Fast Meter Configuration Messages........................... 6.14
Table 6.10 A5D2/A5D3 Demand/Peak Demand Fast Meter Message .................................................. 6.15
Table 6.11 A5CE Fast Operate Configuration Block............................................................................. 6.15
Table 6.12 A5E0 Fast Operate Remote Bit Control............................................................................... 6.16
Table 6.13 A5E3 Fast Operate Breaker Control .................................................................................... 6.17
Table 6.14 Communications Settings..................................................................................................... 6.19
Section 7: ASCII Command Reference
Table 7.1 ACC and 2AC Commands ..................................................................................................... 7.2
Table 7.2 SEL-587Z Control Subcommands ......................................................................................... 7.7
Table 7.3 Password Requirements and Default Passwords.................................................................. 7.12
Table 7.4 SET Command Parameters ..................................................................................................7.14
Table 7.5 Valid SHO Commands ......................................................................................................... 7.16
Table 7.6 STA Command..................................................................................................................... 7.19
Table 7.7 SEL-587Z Relay Word and Its
Correspondence to TAR Command and Front-Panel LEDs ............................................... 7.20
Table 7.8 SEL-587Z Relay Commands ............................................................................................... 7.22
Table 7.9 SET/SHOW Command Options........................................................................................... 7.22