7.14
SEL-587Z Instruction Manual Date Code 20020903
ASCII Command Reference
Command Definitions
QUI (Quit)
Access Levels 1, 2
The relay returns to Access Level 0 when you enter the QUI command:
=>QUI <Enter>
The relay sets the port access level to 0 and displays the following heading
prompt:
BUS 1 Date: 03/05/01 Time: 08:55:33.986
STATION A
=
The “=” prompt indicates the relay is in Access Level 0.
The QUI command remaps the front-panel targets to the Relay Targets
(TAR 0) and terminates the SEL LMD connection if it is established (see SEL
Distributed Port Switch Protocol (LMD) on page 6.10 in Section 6: Serial Port
Communications).
SER (Sequential
Events Recorder)
Access Levels 1, 2
Use the SER command to view Sequential Events Records. For more
information on SER reports, see Sequential Events Recorder (SER) Report on
page 9.17 in Section 9: Event Reports and SER.
SET
Access Level 2
Use the SET command to view or change the relay settings. This is an Access
Level 2 command.
Table 7.4 SET Command Parameters
Class Settings
SET Relay settings
SET L Logic settings
SET P 1 Rear port settings
SET P F Front port settings
SET T Text settings
SET R SER settings
To Next Page
