2.11
Date Code 20020903 SEL-587Z Instruction Manual
Installation
Circuit Board Jumpers and Battery
Step 6. Remove the battery from beneath the clip and install a new one.
The positive side (+) of the battery faces up.
Step 7. Slide the draw-out assembly into the relay chassis.
Step 8. Reconnect the analog signal ribbon cable and power supply
cable.
Step 9. Replace the relay front panel and reenergize the relay.
Step 10. Set the relay date and time (see DAT (Date) on page 7.8 in
Section 7: ASCII Command Reference and TIM (Time) on
page 7.21 in Section 7: ASCII Command Reference).
To Next Page
Loading...
