SPECIAL PROCEDURES
NOTICE
Inspect water intake grate
for damage. Refer to an authorized
Sea-Doo dealer for repair as neces-
sary.
For ease of access to the jet pump
area, move the iBR to the forward po-
sition, refer to
iBR OVERRIDE FUNC-
TION
for detailed instructions.
iBR Override Function
When the iBR override function is acti-
vated, it allows the user to electrically
move the iBR gate and nozzle through
its full range of motion using the VTS
control button.
NOTE: The iBR override function is
only available when the engine is not
running.
WARNING
When moving the iBR gate using
the iBR override function, ensure
noone is near the rear of the water-
craft. Movement of the gate may
squeeze fingers.
NOTICE
An object or tool caught
in the iBR system when using the
iBR override function may cause
damage to the iBR components. Re-
move all rigid foreign objects that
may obstruct the iBR gate travel be-
fore moving it.
WARNING
If it is necessary to reach in to re-
move any foreign object caught
in the propulsion system, strictly
observe the following before pro-
ceeding:
– Remove tether cord from the
engine cut-off switch.
– Waitatleast5minutes.
– Do not press on START/STOP
button. Should the START/
STOP button is pressed, wait
another 5 minutes.
Activating iBR Override Function
To activate the iBR override function,
carry out the following step.
1. Power up the electrical system by
pressing the start/stop.
2. Install the tether cord on the engine
cut-off switch.
NOTE: The tether cord must be in-
stalledtoensuretheinformationcen-
ter will not shut off all indications after
its self test function. Electrical power
will stay ON for approximately 3 min-
utes.
3. Press the Mode button on the RH
handlebar repeatedly until SET-
TINGS is visible in the digital display
of the information center.
smo2009-002-114_y
FUNCTION SELECTED - SETTINGS
4. Press the SET button (RH handle-
bar) to display DOCK MODE.
smo2009-002-114_bb
FIRST AVAILABLE MODE FUNCTION - DOCK
MODE
______________
119
To Next Page
Loading...
Need help?
General