SPECIAL PROCEDURES
5. Press the UP/DOWN arrow button
to display IBR OVR.
smo2009-002-114_ff
SECOND AVAILABLE MODE FUNCTION - IBR
OVR MODE
6. Press the SET button to enter IBR
OVR function and display OVR OFF.
smo2009-002-114_hh
MODE FUNCTION ENTERED - OVR OFF
7. Press the UP/DOWN arrow button
(RH handlebar) to display OVR ON.
smo2009-002-114_gg
MODE FUNCTION ACTIVATED - OVR ON
8. Press the SET button to select the
OVR ON function. The gauge will
return to its normal display.
9. Press theVTS UP/DOWN arrowbut-
tontomovetheiBRgatetothede-
sired position.
Models Without a VTS UP/DOWN
Button
NOTE: On models without the VTS
UP/DOWN button, use the UP/DOWN
arrow button on the RH handlebar to
move the iBR to the desired position
once the iBR override function has
been activated as described in the pre-
vious steps.
All Models
10. Remove the tether cord from the
engine cut-off switch
WARNING
If it is necessary to reach in to re-
move any foreign object caught
in the propulsion system, strictly
observe the following before pro-
ceeding:
– Remove tether cord from the
engine cut-off switch.
– Waitatleast5minutes.
– Do not press on START/STOP
button. Should the START/
STOP button be pressed, wait
another 5 minutes.
Deactivating iBR Override Function
There are three ways to deactivate the
iBR override function:
– Repeat steps in
ACTIVATING iBR
OVERRIDE FUNCTION
and press
the SET button when OVR OFF is
visible.
– Wait for the electrical power to shut
off.
– Start the engine.
NOTE: When the engine is started,
the iBR OVR function is deactivated
and the iBR gate will move to the neu-
tral position.
120
______________
To Next Page
Loading...
