Section 07 FUEL SYSTEM
Subsection 02 (FUEL CIRCUIT)
SMR2000-055_07_02A.FM 07-02-5
Disconnect fuel lines from baffle pick up and loos-
en lower clamp no. 7.
TYPICAL
1. Disconnect fuel hoses
2. Loosen lower clamp
Disconnect wiring harness of fuel sender.
Remove baffle from fuel tank.
Remove upper clamp no. 9 from adapter no. 8
and slide adapter from baffle.
Push inward on the 3 clips at the base of the baffle
in order to remove the filter. Pry base off using a
small slotted screwdriver (if necessary).
Electric Fuel Pump
DI Models
Refer to ENGINE MANAGEMENT (DI) section.
Fuel Tank
RX/RX DI Models
NOTE: It is necessary to remove the engine. Re-
fer to ENGINE section.
All Models
Siphon fuel tank.
Remove fuel baffle pick up or electric fuel pump
on DI models. See above.
Detach all fuel tank straps.
Pull out fuel tank.
INSPECTION
Fuel Filter
Carburetor-Equipped Models
Inspect fuel filter condition. Carefully use low
pressure compressed air to clean fuel filter. Re-
place filter if permanently clogged or damaged.
Fuel Filter Bowl
Check filter bowl for water contamination.
Gasket
Inspect gasket condition. Make sure gasket no. 3
is well positioned into the filter bowl no. 2.
1. Gasket in bowl
DI Models
Inspect filter/strainer condition. Carefully use low
pressure compressed air to clean. Replace if per-
manently clogged or damaged.
The filter at fuel pump inlet is not replaceable indi-
vidually. The complete fuel pump unit has to be
replaced.
Fuel Filler Hose
All Models
Verify fuel filler hose no. 4 for damage. Always en-
sure that clamps no. 3 are well positioned and
tightened. Torque clamps to 4 N•m (35 lbf•in).
WARNING
Fuel is flammable and explosive under cer-
tain conditions. Always work in a well venti-
lated area. Always wipe off any fuel spillage
from the watercraft.
F02F1OA
1
2
WARNING
Ensure that there is no leakage from the fuel
filter.
F01F02A
1
To Next Page
Loading...
