Section 10 PROPULSION SYSTEM
Subsection 04 (REVERSE SYSTEM)
10-04-2 SMR2000-067_10_04A.FM
DISASSEMBLY
Reverse Gate
To remove reverse gate, refer to JET PUMP section.
Reverse Cable
Unscrew bolt no. 12, washers and the elastic stop
nut retaining reverse cable no. 13 on pivot arm.
Remove the glove box. Refer to HULL/BODY.
On the interior lever no. 14, unscrew the elastic
stop nut and the washer retaining the reverse ca-
ble.
NOTE: Before removing reverse cable from hull,
note cable routing for reinstallation.
Inner Lever
Detach the reverse cable from inner lever no. 14.
Unscrew the shift lever retaining bolt no. 15,
washer and nut, then remove inner lever.
Shift Lever
Unscrew the shift lever retaining bolt no. 15,
washer and nut.
Disengage the shift lever slots from inner lever
tabs, then remove the shift lever no. 16.
Reverse Cable Support
Remove:
– shift lever
– inner lever
– bracket no. 17
– bolts no. 18.
Withdraw reverse cable support no. 19.
Handle Housing
Remove:
– shift lever
– inner lever
– reverse cable support
– bolts no. 20.
Then, remove handle housing no. 21.
INSPECTION
Visually inspect parts for wear or cracks. Replace
all defective parts.
ASSEMBLY
Assembly is essentially the reverse of disassem-
bly procedures. However pay particular attention
to the following.
Inner Lever
Apply synthetic grease on the inner lever pivot and
in the reverse cable support hole.
Install the inner lever in a rotating movement. En-
gage properly the inner lever tabs in the shift lever
slots.
Make sure the shift lever action is smooth and pre-
cise. Forward and reverse positions should be
easy to select with a detent position between
each.
Reverse Gate
Refer to JET PUMP section.
Reinstall glove box.
ADJUSTMENT
Put shift lever in forward position.
Place reverse gate in the up position.
Turn the joint at the end of reverse cable and place
the hole in pivot arm and joint face to face.
Secure with bolt, washers, spacer and elastic stop
nut. Torque to 7 N•m (62 lbf•in).
To Next Page
Loading...
