EasyManua.ls Logo

Sea-doo RX - Other Functions

Sea-doo RX
351 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Section 09 ELECTRICAL SYSTEM
Subsection 05 (INSTRUMENTS AND ACCESSORIES)
09-05-4 SMR2000-063_09_05A.FM
Warning Light
The red warning LED (Light-Emitting Diode) blinks
along with the message display to catch your at-
tention.
Fuel Level Display
Bar gauge continuously indicates the amount of
fuel in the fuel tank while riding. A low-fuel condi-
tion is also indicated when it occurs. See Message
Display above.
VTS Position Indicator (if so equipped)
The VTS position indicator shows the riding angle
of the watercraft.
1. Position indicator
2. Bow up
3. Bow down
Display Priorities
The clock, (clock/compass, if so equipped) is the
default display mode. The default display is the
one that appears when the information center is
first activated or displayed back after an alternate
display was chosen.
The tachometer, speedometer and chronometer,
are the only other modes that may be chosen to
replace the default display. When one of these is
selected, it will become the default display until it
is changed again.
When another display mode is chosen, the default
display will be displayed back after 4 seconds.
As a self test, all LCD segments and the LED will
turn on for 3 seconds each time the information
center is activated.
In the event of a warning message, the message
will blink and override the units display.
If more than one warning message occurs, the
blinking messages will scroll every 4 seconds.
Other Functions
The following describes how to select other avail-
able functions.
Language Option
While in the clock/compass mode:
1. Press and hold for 2 seconds
1. Repeatedly press
1. Press to end
F00L2DA
123
F00L2BC
1
F00L2BB
1
F00L2BC
1
www.SeaDooManuals.net

Table of Contents