Section 09 ELECTRICAL SYSTEM
Subsection 05 (INSTRUMENTS AND ACCESSORIES)
SMR2000-063_09_05A.FM 09-05-3
The information center includes the following dis-
play areas.
1. General display
2. Message/units display
3. Warning light
4. Fuel level display
5. VTS position indicator (if so equipped)
General Display
The default display is the clock (or clock/compass
if so equipped) unless another mode has been
selected. See Display Priorities below.
Repeatedly pressing the MODE button scrolls the
following displays: Tachometer, speedometer,
peak speed, average speed, trip meter, hourmeter,
water temperature, exterior temperature (if so
equipped) and chronometer.
1. Press to change display mode
When you are satisfied with your choice, stop press-
ing the button.
Clock: Indicates the actual time in hours and min-
utes (hh:mm).
Clock/Compass (if so equipped): Displays the
cardinal points to indicate the orientation of the
watercraft.
Tachometer: Indicates the revolutions per minute
(RPM) of the engine.
Speedometer: Indicates the speed of watercraft
in kilometers per hour (KPH) or miles per hour
(MPH).
Peak Speed: Indicates the top speed the water-
craft reached (PK KPH or PK MPH).
Average Speed: The information center approxi-
mately calculates and displays the average speed
(AV KPH or AV MPH) of the watercraft since the
last engine start.
Trip Meter: The information center approximately
calculates the distance based on the operation time
and the watercraft speed and displays the result in
kilometers (KM) or miles (MILES).
Hourmeter: Displays the time in hours of the wa-
tercraft usage.
Water Temperature: Displays the water temper-
ature (L TEMP) in degrees Celsius (°C) or Faren-
heit (°F).
Exterior Temperature (if so equipped): Displays
the exterior air temperature (E TEMP) in degrees
Celsius (°C) or Fahrenheit (°F).
Chronometer: Allows to measure an interval of
time in hours and minutes (hh:mm).
Message Display
The Information Center features a display area
that blinks a message whenever one of the follow-
ing circumstances occurs:
• compass error (COMPAS)
• maintenance (MAINT)
• engine overheating (H-TEMP)
• low fuel (FUEL-LO)
• low oil (OIL LOW)
• low voltage (12 V LOW)
• fuel injection system sensors and major compo-
nents (DI models).
Except for low fuel and low oil, which can be cor-
rected by refilling, refer to DIAGNOSTIC PROCE-
DURES section when other messages occur.
The warning light will blink at the same time.
F00L2CA
1
2
34
5
F00L2BB
1
WARNING
Use the compass as a guide only. Not to be
used for navigation purposes.
To Next Page