Section 11 STEERING SYSTEM
Subsection 04 (ALIGNMENT)
SMR2000-069_11_04A.FM 11-04-1
ALIGNMENT 0
Position handlebar in straight ahead position by
measuring each side the distance from handlebar
grip end to floorboard.
TYPICAL
1. Measuring handlebar grip end/floorboard distance
Check jet pump nozzle position by placing a
straight edge on nozzle outer end. Measure the
distance on each side of the straight edge. It must
be equalled.
TYPICAL
1. Measure the distance on each side of the straight edge
If necessary, steering alignment adjustment should
be performed at steering cable support.
Open storage compartment cover and remove bas-
ket.
Loosen 2 bolts retaining block at cable support.
Turn adjustment nut as required.
1. Retaining block
2. Adjustment nut
3. Loosen bolts
After adjustment, torque retaining block bolts to
6N•m (53 Ibf•in).
CAUTION: Verify when the handlebar is turned
completely to the left or right side, that there is
no interference with venturi.
F01K07A
1
F01J03A
1
1
3
F01K18A
2
To Next Page