Sea-doo RX - Page 338

Section 13 TECHNICAL DATA
Subsection 02 (RX DI AND GTX DI MODELS)
SMR2000-072_13_02A.FM 13-02-5
TIGHTENING TORQUES RX DI (5646/5656) GTX DI (5649/5659)
ENGINE
Exhaust manifold screw 40 N•m (30 lbf•ft)
Magneto flywheel nut 115 N•m (85 lbf•ft) (1)
Flywheel screw (PTO side) 115 N•m (85 lbf•ft) (1)
Crankcase screws
M8 27 N•m (20 lbf•ft) (3)(4)
M10 40 N•m (30 lbf•ft) (3)(4)
Crankcase/engine support nuts 25 N•m (18 lbf•ft) (1)
Engine mount/hull 25 N•m (18 lbf•ft (1)
Cylinder head screws 40 N•m (30 lbf•ft) (1) (4)
Cylinder screws 24 N•m (30 lbf•ft) (4)
Tuned pipe flange screws/nut 48 N•m (35 lbf•ft) (1)
Tuned pipe fixation screws 25 N•m (18 lbf•ft) (1)
Magneto housing cover screws 9 N•m (80 lbf•in)(5)
Starter mounting screws 10 N•m (89 lbf•in (1)
Spark plugs Hand-tighten then tighten an additional 1/4 turn
JET PUMP
Impeller 113 N•m (83 lbf•ft) (1)
Pump/hull nuts 31 N•m (23 lbf•ft) (1)
Venturi/pump housing screws 21 N•m (16 lbf•ft) (1)
Pump housing cover screws 7.5 N•m (66 lbf•in)(1)
Inlet grate screws 11 N•m (97 lbf•in)(1)
Riding plate screws 22 N•m (17 lbf•ft) (2)
STEERING
Cable retaining block bolts 6 N•m (53 lbf•in)
Steering cable/stem arm bolt 3 N•m(26 lbf•in)
Steering stem arm bolts 6 N•m(53 lbf•in)
Handlebar clamp bolts 26 N•m (19 lbf•ft)
Steering cable ball joint (nozzle) 7 N•m (62 lbf•in)
Steering support bolts 12 N•m (9 lbf•ft) (1)
Handlebar grip screw 7 N•m(62 lbf•in)
ADDITIONAL INFORMATION: Apply where indicated: (1) Loctite 243 (blue)
(2) Loctite 271 (red)
(3) Loctite 518
(4) Synthetic grease
(5) Anti-seize lubricant

WARNING
Correct torques and use of Loctite must be strictly followed.
www.SeaDooManuals.net