Seat LEON 2024 - Keyless Access System

Opening and closing
99
Keyless Access system
A
B
●
Open the driver’s door. If the vehicle is fitted
with an anti-theft alarm, it will trigger immedi-
ately ›››page106.
●
Switch the ignition on. Please note: to turn on
the ignition, place the vehicle key at the bottom
of the central armrest box, as close as possible
to the Kessy logo .
This completes the synchronization.
Keyless Access system
Locking and unlocking with the Key-
less Access system
Fig.73 Keyless Access: proximity zones.
Fig.74 Door handle: sensor surfaces.
›››Fig.74
Unlocking sensor surface on the inside of
the door handle.
Locking sensing surface on the outside of
the door handle.
Depending on the equipment, the vehicle may
have the Keyless Access system. This is a key-
less locking and starting system that can un-
lock and lock the vehicle without actively using
its key. For this, it is only necessary that there
is a valid vehicle key in the detection area cor-
responding to the attempted access to the ve-
hicle.
Configuring the Keyless Access system
The behaviour of the Keyless Access system
can be adjusted in the Vehicle settings menu
of the Infotainment system ›››page39.
If the Keyless Access function is disabled, its
operation is limited.
Unlocks the vehicle.
●
Touch the sensor surface on the inside of the
handle
A
. All turn signals flash twice.
If selective opening is fitted, touching the sen-
sor's surface twice unlocks the entire vehicle.
If the vehicle is not unlocked for an extended
period, the function is deactivated. The function
will reactivate the next time that the vehicle is
unlocked with the remote control.
Locks the vehicle.
●
Park the vehicle.
●
Touch the sensor surface
B
›››Fig.74 on the
outside of the door handle. All turn signals flash
once.
To check that the vehicle is properly locked,
the unlocking function is deactivated for a few
seconds.
Vehicle locking when walking away
The vehicle may lock automatically when when
you walk away from it. The following conditions
must be met simultaneously:
●
The function is active in the infotainment sys-
tem.
●
All vehicle keys are outside the locking area.
All turn signals flash once when automatic
locking has been performed successfully.
Automatic locking will not occur if there is an-
other vehicle key in the vehicle.