Seat LEON 2024 - Changing Memory

24
Driver information
1)
Not available in all countries.
–
–
–
–
–
–
–
–
–
–
–
–
●
If warnings are shown about existing faults
when the ignition is switched on, it might not
be possible to change the settings or display
the information as described. In this case, go
to a specialised workshop and request a re-
pair.
Driving data display
The driving data display shows a range of driv-
ing data and consumption values.
Change from one display to another
●
Turn the right thumbwheel of the multifunc-
tion steering wheel ›››page35.
Changing memory
●
Depending on the view, select Driving data
and press the left arrow or the button on the
multifunction steering wheel.
Since start: The memory is deleted if the
journey is interrupted for more than 2 hours.
Since refuel: Display and storage of the
journey data and the consumption values
collected. When refuelling, the memory is
deleted.
Long-term: This memory contains travel
data up to a maximum of 19hours and
59 minutes or 99 hours and 59 minutes, or
up to a maximum of 1999.9 km or 9999.9
km. When one of these values is exceeded
(varies depending on the version of the in-
strument cluster), the memory is deleted.
Delete journey data presets
●
Select the memory you want to delete - ei-
ther “Since start” or “Long-term”. The “Since
refuelling” memory is only cleared when refu-
elling.
●
Press and hold the button on the multi-
function steering wheel for approximately 2
seconds.
Select the instructions
On the instrument cluster, it is selected man-
ually using the button on the multifunction
steering wheel. To access the contents of the
tube, rotate the right hand thumbwheel up/
down.
Current consumption: The current fuel
consumption display operates throughout
the journey, in litres/100 km; and with the
engine running and the vehicle stopped, in
litres/hour.
Average consumption: The average fuel
consumption is displayed after driving for
approximately 300 metres.
Travelling time: This indicates the hours
(h) and minutes (min) since the ignition was
switched on.
Range: Approximate distance in km that
can still be travelled if the same driving
style is maintained.
AdBlue range or : Approximate distance
in km that can still be travelled with the
current level of the AdBlue® tank with the
same driving style. The indication appears
from a range of less than 2400 km and
cannot be deactivated.
1)
Distance travelled: Distance covered in
km (miles) after switching on the ignition.
Average speed: The average speed will
be shown after driving for approximately
100 metres.
Boost/Torque: Indicates the power and
torque of the combustion engine (does not
indicate electric mode).
FAS: Reduced assistant indication.
Oil temperature display
The engine reaches its operating temperature
when, under normal driving conditions, the
oil temperature is between 80°C (176°F) and
120°C (248°F). If a great eort is required from
the engine and the outside temperature is high,
the engine oil temperature may increase. This is
not a problem as long as the warning lamps
or ›››page350 do not appear on the dis-
play.