Fuel and exhaust gas cleaning
●
Fill with AdBlue® until the nozzle stops for the
first time.
●
Close the SCR tube by turning it clockwise
until you hear a click.
Operations before driving
●
After refilling the tank, only switch on the igni-
tion.
●
Leave the ignition on for at least 30 seconds
for the system to detect the fluid load.
●
Make sure you wait for at least 30 seconds
before starting the engine!
WARNING
AdBlue® should only be stored in its origi-
nal container, which should be tightly closed
and kept in a safe place.
NOTICE
●
When refilling, the nozzle grip should be
aligned downward. Otherwise the nozzle will
not connect automatically.
●
Do not try to add any more additive after
the nozzle has stopped for the first time. The
AdBlue® tank could overflow and AdBlue®
could spill out.
●
Only use AdBlue® that complies with the
ISO 22241-1 standard. Only use original con-
tainers.
●
Never mix AdBlue® with water, fuel or addi-
tives. Any type of damage caused by such a
mixture will not be covered by the warranty.
●
Never pour AdBlue® into the fuel tank! This
could result in engine damage.
●
Do not carry the refill bottle inside the
vehicle. If there is a leak (due to tempera-
ture changes or damage to the bottle), the
AdBlue® may damage the vehicle's interior.
For the sake of the environment
Dispose of the refill bottle in an environment-
friendly manner.
Note
Suitable AdBlue® refill bottles can be pur-
chased from SEAT dealerships.
Troubleshooting
AdBlue® level too low
The indicator lamp lights up red. The engine
cannot be restarted!
Stop the vehicle in a suitable, safe and flat area
then top up with the minimum required quantity
of AdBlue® ›››page321.
together with : Fault in the AdBlue
system®
The control lamps light up red. The engine
cannot be restarted!
Go to a specialised workshop and get the sys-
tem checked.
The AdBlue® reserve is low
The indicator lamp lights up yellow.
Top up AdBlue® within the number of kilometres
(or miles) that are indicated ›››page321.
together with : Fault in the
AdBlue® system.
The control lamps light up yellow. There is a
fault in the AdBlue® system or non-conforming
AdBlue® fluid has been added. Go to a special-
ised workshop and get the system checked.
Engine management and
emissions control system
Introduction
WARNING
Due to the high temperatures reached by the
exhaust gas scrubbing system, you should
not park your vehicle near a surface that can
catch fire easily. Fire hazard!