Seat functions
Memory function
Fig.101 On the outer side of the driver's seat:
memory buttons.
Memory buttons
The memory buttons can be used to save and
activate settings for the driver seat and exterior
mirrors.
The settings will also be saved in the user of the
online services.
Save the settings for the driver seat and ex-
terior mirrors for forward gear
●
Apply the electronic parking brake.
●
Set the gearbox to the neutral position.
●
Switch the ignition on.
●
Adjust the driver seat and exterior mirrors.
●
Press for longer than 1 second ›››Fig.101.
●
Press the memory button in which to store the
settings within approx. 10 seconds. An audible
signal confirms that they have been saved.
Save the settings of the front passenger ex-
terior mirrors for reversing.
●
Apply the electronic parking brake.
●
Set the gearbox to the neutral position.
●
Switch the ignition on.
●
Press whichever memory button you want.
●
Select reverse gear.
●
Adjust the front passenger exterior mirror so
that you can see, for example, the kerb edge
well.
●
The set position for the mirrors is automati-
cally saved and assigned to the key with which
you unlocked the vehicle.
Activating the settings
●
With the vehicle stopped and the ignition
switched on, press and hold the correspond-
ing memory button until the saved position is
reached.
●
OR: With the ignition switched o and the
driver's door open, briefly press the corre-
sponding button.
The front passenger side exterior mirror auto-
matically changes from the position stored for
reversing as soon as the vehicle moves forward
at a speed of at least 15km/h (10mph) or when
the gear selection lever is changed to a position
other than R ›››page140.
Initialising the seat position memory
If, for example, the driver seat has been re-
placed, the position memory system must be
restarted.
Restarting deletes all memories and assign-
ments of seats with memory functions. The
memory keys can then be programmed again.
●
Open the driver's door and do not get into the
vehicle.
●
Change the seat settings from outside.
●
Tilt the backrest fully forward.
●
Release the control to adjust the inclination
and press it again until an audible signal
sounds.
WARNING
Only set the memory function when the vehi-
cle is stationary.
Note
If the driver's door is opened approx. 10 mi-
nutes after the vehicle was unlocked or later,
the driver seat and the exterior mirrors do not
move automatically.
To Next Page
Loading...
