NOTICE
●
The maximum weight that can be loaded
on the luggage compartment variable floor
in the top position is 100 kg.
●
Do not let the luggage compartment floor
fall when closing it. Always carefully guide
it downwards in a controlled manner. Other-
wise, the lining and the floor of the luggage
compartment could be damaged.
Partition net
Partition net behind the rear seat
✓ Valid for: LEON Sportstourer
Fig.187 In the luggage compartment:
securing the partition net.
Fig.188 In the luggage compartment:
removing the partition net.
Pulling out and securing the partition net
●
Pull up handle ›››Fig.187
2
to remove the
net from the casing
4
.
●
Hook in the partition net on the right or left
side
3
(magnified image).
●
Hook in the partition net into the housing on
the other side
1
by pulling the rod.
The partition net is properly assembled when
the T-shaped ends are firmly secured in the
corresponding housings
3
and
1
.
Retracting the partition net
●
Unhook the rod from the housings
3
and
1
.
●
Roll up the net into the casing
4
lowering it
with your hand.
Removing the partition net
●
Fold the rear seat backrests forward.
●
Press the left or right release catch
›››Fig.188 in the direction of the arrow
1
.
●
Remove the casing from the support in the
direction of the arrow ›››Fig.188
2
.
Fitting the partition net
●
Fold the rear seat backrests forward.
●
Fit the casing in the right and left supports.
●
Press the casing into the left and right sup-
ports in the opposite direction to the arrow
›››Fig.188
2
until it engages. The red mark-
ings on the release buttons should no longer be
visible.
WARNING
●
Always secure objects, even when the par-
tition net is properly assembled.
●
There should be nobody behind the as-
sembled partition when the vehicle is mov-
ing.
●
The attachments on the backs of the rear
seats must never be used to fit the partition
net when the rear seat backs are in their ver-
tical position.
To Next Page
Loading...
