Auxiliary heating (additional heating)
Flashes for around 5 seconds
●
In orange: The battery in the remote control is
flat. No on or o o signal has been received.
Changing the battery of the radio-operated
remote control
When pressing the buttons, if the control lamp
of the remote
1
flashes for approx. 5 orange
or does not light up, the batteries must be re-
placed.
The battery is located beneath a cover on the
back of the remote control.
●
To open the cover, lift it slightly at the bottom
and slide it down.
●
Remove the battery.
●
Insert the new battery. When doing so, take
into account the polarity and use batteries of
the same type››› .
●
Replace the battery cover by inserting the
tabs at the top and pressing the bottom.
Range
The receiver is inside the vehicle. The remote
control, when fitted with new batteries, has a
range of several hundred metres. Obstacles
between the remote control and the vehicle,
bad weather conditions and discharged batter-
ies can considerably reduce the range of the
remote control.
WARNING
Swallowing a battery with a diameter of 20
mm or any other button battery can cause
serious injuries or even death within a very
short time.
●
Always keep the radio remote control and
key fobs containing batteries, as well as
spare batteries, button cells and other bat-
teries larger than 20 mm, out of the reach of
children.
●
If you suspect that someone may have
swallowed a battery, seek medical attention
immediately.
NOTICE
●
The remote control contains electronic
components. Therefore, avoid getting it wet
and avoid impacts or direct sunlight.
●
The use of unsuitable batteries may dam-
age the remote control. Therefore, always
replace the old battery with a new one of the
same voltage, size and specification.
For the sake of the environment
●
Dispose of used batteries in an environ-
mentally friendly manner.
●
The remote control battery may contain
perchlorate. Please observe the legal provi-
sions regarding its disposal.
●
Make sure that it is not possible to operate
the remote control unintentionally in order to
avoid switching on the auxiliary heating with-
out intending to.
Programming the auxiliary heater
The activation of the parking ventilation for a
scheduled time is only valid for a single ventila-
tion process. The departure time must be for
each newly programmed ventilation process.
Before programming the departure time, you
must check that the date and time of the vehi-
cle are correctly set.
When programming a departure time, the vehi-
cle automatically calculates, depending on the
environmental conditions, the necessary oper-
ating time of the parking ventilation.
To Next Page
Loading...
