Troubleshooting
There is a defect in the electronic park-
ing brake
The control lamp lights up in yellow.
Visit a SEAT dealer or other specialist workshop.
The electronic parking brake does not re-
lease.
The 12-volt battery is discharged.
●
Use the jump start ›››page327.
The electronic parking brake makes noises
●
When the electronic parking brake is applied
and released, noises may be heard.
●
The system performs automatic and audible
checks sporadically in the parked vehicle if
some time elapses without the electronic park-
ing brake being used.
Auto Hold function
Fig.152 In the lower part of the centre
console: Auto Hold function button.
The Auto Hold function holds the vehicle at a
standstill and prevents it from moving without
it being necessary to keep the brake pedal de-
pressed.
When the Auto Hold function is switched
on, the lamp on the instrument cluster
lights up grey.
When the Auto Hold function is active,
the control lamp on the instrument clus-
ter lights up green.
The control lamp of the button
›››Fig.152 remains on when the Auto
Hold function is connected.
Requirements
●
The driver's door is closed.
●
The driver’s seatbelt is buckled.
●
The engine is running.
Connecting and disconnecting
Press the Auto Hold button ››› . The control
lamp on the button turns on when the Auto
Hold function is switched on. The function is
now available to be activated. The lamp on the
button goes out when the Auto Hold function is
switched o.
Switching on and o automatically
If the Auto Hold function was switched on with
the Auto Hold button before disengaging the
ignition, the function will remain on after the
ignition is re-engaged.
If the Auto Hold function was not switched on, it
will remain o next time the ignition is switched
on.
The Auto Hold function is automatically turned
o if the following conditions are met:
1. If any of the requirements of the function
are no longer met.
2. If the engine runs erratically or has any
anomaly.
3.
If the engine stalls.
To Next Page
Loading...
