Additionally it can be switched on and o by
accessing the Assistants menu on the instru-
ment cluster.
When the lane departure warning is ready to
operate, the indications in the control lamps will
turn on briefly as confirmation.
When the vehicle is restarted, the last adjust-
ment in the system will remain active.
Light indication
The control lamp provides an indication on the
corresponding side regarding the trac situa-
tion behind the vehicle, if it is deemed to be
critical. The control lamp on the left-hand side
indicates the trac situation to the rear left of
the vehicle, and the control lamp on the right-
hand side indicates the trac situation to the
rear right of the vehicle .
Keep the warning lamps zone of the lane de-
parture warning free of objects, adhesives or
the likes that may interfere with your visibility.
It lights up
It turns on once briefly: the lane departure warning
is activated and ready to operate, i.e. when acti-
vating the system.
It lights up continuously: the lane departure warn-
ing has detected a vehicle in the blind spot.
Flashes
A vehicle has been detected in the adjacent lane
and the turn signal has been engaged in the direc-
tion of the detected vehicle.
For vehicles that are also equipped with Lane As-
sist ›››page210, a warning to switch lanes will
also appear even though the turn signal has not
been engaged (Lane Assist “Plus”).
The control lamps light up when the ignition is
switched on and should turn o after approxi-
mately 2 seconds. This is the time taken for the
function check.
If there are no indications from the control lamp
of the lane departure warning, this means that
the lane departure warning has not detected
any other vehicles at the rear area.
When the exterior lighting is low, the intensity
with which the control lamps come on is dim-
med. The user can modify the intensity of the
control lamps with up to 5 levels in the infotain-
ment system menu.
Lane assist Plus.
The Lane Assist Plus function can be used by
activating the Lane Assist ›››page210 and
Side Assist functions. In this case its functions
are expanded as described below.
If the driver initiates a lane change manoeuvre
in a potential critical situation:
●
The lamp flashes in the corresponding rear-
view mirror even though the turn signal has not
been activated.
●
The steering wheel vibrates to warn the driver
of the risk of collision.
●
torque is applied to correct the steering and
return the vehicle to its lane.
Driving situations
Fig.149 Overtaking with trac behind the
vehicle.
Fig.150 Overtaking in the central lane and then
joining the right lane.
To Next Page
Loading...
